Home > Arduino & SCM Supplies > 1.2A
1.2A Mini Dual Motor Driver Module Full-bridge Driver for Arduino
The motor driver can control up to two DC motors at a constant current of 1.2A (3.2A peak). Two input signals (IN1 and IN2) can be used to control the motor in one of four function modes - CW£¬ CCW£¬ short-brake£¬ and stop. The two motor outputs (A and B) can be separately controlled£¬ the speed of each motor is controlled via a PWM input signal with a frequency up to 100kHz. The STBY pin should be pulled high to take the motor out of standby mode. Note: However£¬ when using the board at currents up to 0.6A£¬ it may be necessary to improve thermal performance with a heat-sink. Features: - Driver Chip: TB6612FNG - Power supply voltage: VM=15V max£¬ VCC=2.7-5.5V - Output current: Iout=1.2A(average) / 3.2A (peak) - Standby control to save power - CW/CCW/short brake/stop motor control modes - Built-in thermal shutdown circuit and low voltage detecting circuit - All pins of the TB6612FNG broken out to 2.54mm spaced pins£¬ and it can be plugged onto the breadboard. - Filtering capacitors on both supply lines - Great for DIY and smart car projects