Home > Arduino & SCM Supplies > 1A
1A DRV8833 Dual Motor Driver Module Full-bridge Driver for Arduino
The motor driver can control up to two DC motors at a constant current of 1.0A (4A peak). Two input signals (IN1 and IN2) can be used to control the motor in one of four function modes - CW£¬ CCW£¬ short-brake£¬ and stop. The two motor outputs (A and B) can be separately controlled£¬ the speed of each motor is controlled via a PWM input signal with a frequency up to 100kHz. Note: However£¬ when using the board at currents up to 0.6A£¬ it may be necessary to improve thermal performance with a heat-sink. Features: - Driver Chip: DRV8833 - Power supply voltage: VM = 2.7-10.8V - Output current: Iout=1.0A(average) / 4A (peak) - Standby control to save power - CW/CCW/short brake/stop motor control modes - Built-in thermal shutdown circuit and low voltage detecting circuit - All pins of the DRV8833 break out to 2.54mm spaced pins£¬ and it can be plugged onto the breadboard. - Filtering capacitors on both supply lines - Great for DIY and smart car projects