Home > DIY Parts & Components > Jtron
Jtron 1 Series Iron Phosphate Lithium Battery Protection Board - Blue
The protection board uses lithium iron phosphate rechargeable battery protection IC; 1. High-accuracy voltage detection circuit; 2. The terminal is connected charger with high withstand voltage devices; 3. Built-in three-stage overcurrent detection circuit (overcurrent 1£¬ overcurrent 2£¬ load short circuit); 4. Through the MOS transistor can control the battery charging and discharging; 5. Low standby current consumption. Welding Point: B + pick battery cathode; B-connected to the battery negative; P + connection charge / discharge upright pole (charging terminal / discharge side shared) P-connection charge / discharge end of the negative (charging terminal / discharge side shared) Note: 1. Note that the input and output voltage£¬ and load current conditions£¬ the protection board power consumption does not exceed the allowable Power dissipation electrical parameters; 2. Pay particular attention to the load current cannot work long hours between maximum continuous operating current and over-current protection current; 3. The situation is not likely to occur when you connect the battery discharge. In this case£¬ connect the charger can be restored to normal operation; 4. The built-in electrostatic protection board protection circuit£¬ but please do not hand protection when working in electrical panels to touch the plate£¬ so as to avoid damage from static electricity protection board.