Home > Arduino & SCM Supplies > NL6621-Y1
NL6621-Y1 Remote Control Serial Port to Wi-Fi SDK Module for Anduino
NL6621M is a highly integrated SOC£¬ especially for high data throughput and low cost of the wireless LAN products design. It integrates MCU£¬ MAC£¬ 1T1R and RF baseband amplifier with a transceiver in a single chip NL6621M 802.11b/g/n and Wi-Fi direct support (SDIO BSS£¬ STA card mode)£¬ soft AP£¬ WiFi protection set. It also supports WMM-PS and WPA/WPA2 security protocols. NL6621M can be used as acceptor processor control from the device can also be used without any other processor independent WLAN equipment. It supports the common interface including QuadSPI£¬ SPI£¬ I2C£¬ UART£¬ GPIO£¬ I2S£¬ PWM audio£¬ audio. NL6621M can be directly connected with the surrounding devices such as speakers£¬ cameras£¬ flash£¬ LCD£¬ etc.. TCP/IP£¬ UPD£¬ HTTP and other rich Internet protocols have been integrated in NL6621M. High performance wireless transmission£¬ rich interface and protocol support make NL6621M the best choice for wireless audio£¬ wireless video£¬ wireless smart home and wireless medical£¬ etc.. Two development: fully open source£¬ Standar_SDK£¬ Wifi-Uart_SDK£¬ Homekit_SDK Apple£¬ Gizwits_SDK; On chip CPU: 1) Frequency can be flexibly configured as: 160M£¬ 120M£¬ 80M£¬ 40M; 2) RAM 448KB (RAM CODE 192K) for WLAN and customers to customize the application use. Wi-Fi network operating mode: (1).BSS STA (2).Soft BSS AP (3).Wi-Fi direct£¨SDIO Network card mode£© (4).Ad hoc (5).DirectConfig(a key fast configuration) Support: 1.802.11b:1£¬ 2£¬ 5.5£¬ 11Mbps 2.802.11g:6£¬ 9£¬ 12£¬ 18£¬ 36£¬ 48£¬ 24£¬ 54Mbps 3.802.11n: 7.2Mbps-72.2Mb£¬ 6.5Mbps-65Mbps 1.UART£¬ which can be used as a high speed data or control interface 2.I2C£¬ EEPROM memory chip can be externally 3. integrated SPI interface£¬ SPI interface can be connected to the display module 4. integrated with up to 32 GPIO interfaces 5. integrated 2 channel pulse width modulation interface 6.1 hard timers and 1 hard watchdog Applications: - Intelligent Security - Internet appliance - smart toys - WIFI light - smart card terminal - WIFI speaker Simple test method: as long as a USB to TTL£¬ respectively£¬ 3.3V£¬ GND£¬ UTXD£¬ URXD£¬ the power module will be able to work properly. The default baud rate is 115200.